Removing a headlamp

1. Open the bonnet. See Opening and closing the bonnet.

2. Remove the screws.


2. Remove the screws.

CAUTION:


CAUTION:
Do not pull the bumper more than 10 mm from its original position.

3. Carefully pull the bumper towards the front of the vehicle and remove the screw.

4. Disconnect the electrical connector and remove the headlamp.

CAUTION:
When fitting the headlamp, take care not to damage the locating points.

Note: When fitting the headlamp, make sure that you fully engage the headlamp in the fixing points.

    See also:

    AM/FM single CD/MP3 satellite compatible sound system
    WARNING: Driving while distracted can result in loss of vehicle control, accident and injury. Ford strongly recommends that drivers use extreme caution when using any device or feature that may ...

    Engine - reassembly
    Note: Ensure that all necessary new oil seals and gaskets have been obtained before starting the reassembly procedure. 1 With everything clean and parts renewed where necessary, commence reassembl ...

    Tailboard (P100 models) - removal and refitting
    Removal 1 Lower the tailboard to the open position. 2 Detach the rear lamp wiring cover on one side of the vehicle by removing the two securing screws (see illustration). 24.2 Rear lamp wiring ...