Steering gear rubber gaiter - renewal

1 Remove the tie-rod end.

2 Unscrew and remove the tie-rod end locknut from the tie-rod.

3 Remove the clips and slide the gaiter from the tie-rod and steering gear.

4 Slide the new gaiter over the tie-rod and onto the steering gear. Where applicable, make sure that the gaiter seats in the cut-outs in the tie-rod and steering gear.

5 Secure the gaiter with new clips.

6 Refit the tie-rod end locknut to the tie-rod.

7 Refit the tie-rod end.

    See also:

    Major operations requiring engine removal
    The following work can only be carried out after removal of the engine from the car: a) Crankshaft main bearings - renewal . b) Crankshaft - removal and refitting. c) Flywheel - removal and refitt ...

    Overhead console (if equipped)
    The appearance of your vehicle’s overhead console will vary according to your option package. Storage compartment (if equipped) Press the release on the door to open the storage compartment. Th ...

    Ignition switch
    WARNING: Never return the key to position 0 or I when the vehicle is in motion. 0 The ignition is off. I The ignition and all main electrical circuits are disabled. Note: Do not leave the igni ...