Bonnet lock - removal and refitting

Models up to 1987
1 Working in the engine compartment, disconnect the cable from the bonnet lock by pulling the cable sheath end fitting from its bracket, then releasing the end fitting from the lock lever.

2 Remove the three securing screws and withdraw the lock from the front panel.

3 Refitting is a reversal of removal.

Models from 1987
4 Remove the radiator grille panel.

5 Disconnect the cable from the bonnet lock by pulling the cable sheath end fitting from its bracket, then releasing the end fitting from the lock lever.

6 Detach the bracing strut from the lock by removing the screw, then remove the two securing screws and withdraw the lock from the front panel.

7 Refitting is a reversal of removal.

    See also:

    Fuse specification chart - Vehicles Built Up To: 07-02-2010
    Engine compartment fuse box 1 Fit a replacement with the same rating as the one you have removed. Central fuse box Rear fuse box 4-door and 5-door Estate ...

    Fuel filler flap - removal and refitting
    Removal 1 Open the filler flap and the tailgate or boot lid, as applicable. 2 Remove the fuel filler cap and then remove the screw securing the filler housing to the fuel tank neck (see illustrat ...

    Idle Speed Control Valve (ISCV) - removal, cleaning and refitting
    Removal 1 Disconnect the battery negative lead. 2 Disconnect the valve wiring plug (see illustration). 12.2 Idle speed control valve - 1.6 EFI engine A Wiring plug B Securing bolts 3 Unscrew t ...