Boot lid lock (Saloon models) - removal and refitting

Removal
1 With the boot lid raised, remove the lock barrel retaining clip.

2 Where applicable, disconnect the operating lever from the central locking solenoid/motor, then withdraw the lock barrel.

3 Remove the three retaining screws from the lock assembly, if necessary loosening the reinforcing plate (see illustration).

10.3 Boot lid lock - Saloon models
10.3 Boot lid lock - Saloon models

A Lock retaining screws B Earth lead
C Reinforcing plate screws

4 Where applicable, disconnect the battery negative lead, the earth lead from the bootlid and the boot lid ajar sensor wiring plug.

Unclip the luggage compartment light switch from the lock assembly, where applicable.

5 Withdraw the lock assembly from the boot lid.

Refitting
6 Commence refitting by inserting the lock assembly and loosely refitting the retaining screws.

7 Insert the lock barrel, where applicable reconnecting the operating lever to the solenoid, and refit the retaining clip.

8 Tighten the lock assembly retaining screws, and where applicable reconnect the earth lead and boot lid ajar sensor wiring plug, and the battery negative lead.

9 If the reinforcing plate was loosened during removal, tighten the retaining screws.

    See also:

    Rear window washer fluid reservoir - removal and refitting
    Removal 1 On models from 1987, the rear window washer circuit shares the same reservoir as the windscreen/headlamp washers. 2 On models up to 1987, the reservoir is located behind the trim panel ...

    Autolock
    The autolock feature will lock all the doors, liftgate and liftgate window when: all doors are closed, the ignition is in the on position, you shift into any gear putting the vehicle in mo ...

    Overview
    The distinctive, all-new Ford Mondeo introduces new technical features to the Ford range and combines these with further improved driving dynamics and safety enhancements. With three distinctivel ...