Exterior rear pillar trim panel (Saloon models) - renewal

1 Remove the interior rear pillar trim panel.

2 Unscrew the three now exposed securing nuts and withdraw the exterior trim panel (see illustration).

34.2 Exterior rear pillar trim panel securing nut locations (arrowed) -
34.2 Exterior rear pillar trim panel securing nut locations (arrowed) - Saloon models A Heated rear window wiring plug

3 Refitting is a reversal of removal, but do not overtighten the securing nuts, as this may result in damage to the rubber seals.

    See also:

    Bumper components - removal and refitting
    Bumper overriders Removal 1 On pre-1986 models the overrider is held to the bumper by a clamp screw. Find this screw on the underside of the bumper and release it - the overrider can then be with ...

    Safety belt extension assembly
    If the safety belt is too short when fully extended, a safety belt extension assembly can be obtained from an authorized dealer. Use only extensions manufactured by the same supplier as the safety ...

    Sump - removal and refitting
    Note: New gaskets and sealing strips must be used on refitting. Removal 1 Disconnect the battery negative lead and drain the engine oil (see Chapter 1). 2 Refer to Chapter 5, Part A and remove th ...