Cab air vent panel (P100 models) - renewal

1 Remove the cab interior side trim panel.

2 Working inside the cab, remove the two rubber grommets from the rear pillar, then unscrew the two now exposed nuts, and withdraw the air vent panel.

3 Refitting is a reversal of removal.

    See also:

    Idle speed linkage clean (Every 12 000 miles (20 000 km) or 12 months)
    On carburettor models which incorporate a stepper motor (ie. Weber 2V from 1985), good electrical contact between the motor plunger and the adjusting screw is essential to maintain a regular idle ...

    Cargo nets
    Cargo retention net To install the cargo retention net cassette: Remove the luggage cover. Push the sliders on the cassette towards each other and insert the telescopic bar into the holes on the ...

    Distributorless Ignition System (DIS) components - removal and refitting
    Electronic modules 1 Refer to Section 6. DIS coil 2 Refer to Section 4. Engine speed sensor Removal 3 Disconnect the battery negative lead. 4 Disconnect the sensor wiring plug (see illustratio ...