Wheel arch liners - renewal

1 Where fitted, the wheel arch liners may be retained by self-tapping screws, plastic clips, or a combination of both.

2 To remove a liner, simply unscrew the retaining screws, or where plastic clips are fitted, release them by turning with a screwdriver (see illustration).

36.2 Releasing a wheel arch liner plastic clip
36.2 Releasing a wheel arch liner plastic clip

3 Refitting is a reversal of removal.

    See also:

    Pistons and connecting rods - removal and refitting
    1.8 litre (R2A type) Removal 1 With the engine removed from the vehicle, remove the sump and the cylinder head. 2 Check the big-end caps for identification marks and if necessary use a centre-pun ...

    Rear suspension and axle assembly (P100 models) - removal and refitting
    Note: All self-locking nuts and spring washers must be renewed on reassembly. Removal 1 Chock the front wheels, jack up the rear of the vehicle and support on axle stands placed under the side me ...

    Airflow meter - removal and refitting
    Note: A tachometer and an exhaust gas analyser will be required to check the idle mixture on completion. 1 Disconnect the battery negative lead. 2 Depress the locking clip on the airflow meter wi ...