General information and precautions

General information
The electrical system is of the 12 volt.

negative earth type. Electricity is generated by an alternator, belt-driven from the crankshaft pulley. A lead-acid storage battery provides a reserve of power for starting and when the demands of the system temporarily exceed the alternator output.

The battery negative terminal is connected to earth - vehicle metal - and most electrical system components are wired so that they only receive a positive feed, the current returning via vehicle metal. This means that the component mounting forms part of the circuit. Loose or corroded mountings can therefore cause apparent electrical faults.

Many semiconductor devices are used in the electrical system, both in the black boxes which control vehicle functions and in other components. Semiconductors are very sensitive to excessive (or wrong polarity) voltage, and to extremes of heat. Observe the appropriate precautions to avoid damage.

Precautions
It is necessary to take extra care when working on the electrical system to avoid damage to semi-conductor devices (diodes and transistors), and to avoid the risk of personal injury. In addition to the precautions given in the Safety first! Section at the beginning of this manual, take note of the following points when working on the system.

Always remove rings, watches, etc before working on the electrical system. Even with the battery disconnected, capacitive discharge could occur if a component live terminal is earthed through a metal object.

This could cause a shock or nasty burn.

Do not reverse the battery connections.

Components such as the alternator or any other having semi-conductor circuitry could be irreparably damaged.

If the engine is being started using jump leads and a slave battery, connect the batteries positive to positive and negative to negative. This also applies when connecting a battery charger.

Never disconnect the battery terminals, or alternator multi-plug connector, when the engine is running.

The battery leads and alternator multi-plug must be disconnected before carrying out any electric welding on the car.

Never use an ohmmeter of the type incorporating a hand cranked generator for circuit or continuity testing.

    See also:

    Windscreen wipers
    Single wipe A Intermittent wipe or autowipers B Normal wipe C High speed wipe D Intermittent wipe Short wipe interval A Intermittent wipe B Long wipe interval C The rotary control can be u ...

    Keyless starting
    WARNINGS: The keyless starting system may not function if the key is close to metal objects or electronic devices such as mobile phones. Always check that the steering wheel lock is deactivated ...

    Arming the engine immobiliser
    The engine immobiliser is armed automatically a short time after you have switched the ignition off. ...