Reversing lamp switch - renewal

1 For automatic transmission models, refer to Chapter 7, Part B. For manual gearbox models, proceed as follows: 2 Disconnect the battery negative lead.

3 Apply the handbrake, jack up the front of the vehicle and support on axle stands (see “Jacking and Vehicle Support”).

4 Working underneath the vehicle, disconnect the wiring plug, then unscrew the switch from the gearbox extension housing.

5 Refitting is a reversal of removal, but make sure that the wiring is routed clear of the exhaust system.

    See also:

    Carburettor (Ford VV type) - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. Note: A new gasket must be used when refitting the carburettor. A tachometer and an exhaust gas analyser will be required to chec ...

    Major operations requiring engine removal
    The following operations can only be carried out after removing the engine from the vehicle: a) Removal of the crankshaft main bearings b) Removal of the crankshaft ...

    Front suspension strut - removal, overhaul and refitting
    Note: A spring compressor tool will be required if the strut is to be dismantled. Removal 1 Loosen the relevant front roadwheel nuts, apply the handbrake, jack up the front of the vehicle and sup ...