Facia panel switches - removal and refitting

1 Disconnect the battery negative lead.

Rocker switches and push button switches
2 Using a thin-bladed screwdriver, carefully prise the switch from the facia panel.

3 Disconnect the wiring plug and withdraw the switch.

4 Refitting is a reversal of removal.

Instrument panel illumination and intermittent wipe rheostats 5 Proceed as described in paragraphs 2 to 4.

Heater blower switch
6 Carefully pull off the switch knob, using pliers with padded jaws if necessary.

7 Using a thin-bladed screwdriver, prise out the switch front plate from the facia panel.

8 Squeeze the switch retaining tabs, then withdraw the switch and disconnect the wiring plug (see illustration).

9.8 Heater blower switch removal. Switch retaining tabs arrowed
9.8 Heater blower switch removal. Switch retaining tabs arrowed

9 Refitting is a reversal of removal.

Loudspeaker balance joystick 10 Using a thin-bladed screwdriver, carefully prise the joystick front plate from the facia panel.

11 Twist the joystick assembly retaining ring anti-clockwise and remove the ring.

12 Working behind the facia panel, disconnect the wiring plug and slide out the joystick assembly.

13 Refitting is a reversal of removal, but note that the wiring plug can only be fitted in one position, and ensure that the joystick assembly locating lug engages in the corresponding hole in the facia panel.

    See also:

    Using the rear view camera
    WARNINGS: The operation of the camera may vary depending on the ambient temperature, vehicle and road conditions. The distances shown in the display may differ from the actual distance. Do not ...

    Automatic transmission selector mechanism check (Every 12 000 miles or 12 months)
    Carry out a thorough road test, ensuring that all gearchanges occur smoothly without snatching, and without an increase in engine speed between changes. Check that all gear positions can be engage ...

    Connecting an external device
    WARNING: Make sure the external device is securely mounted within the vehicle, and that trailing connections do not obstruct any of the driving controls. External devices may be connected using ...