Luggage compartment lamp switch - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 A level-sensitive switch is fitted to the tailgate.

3 Unclip the tailgate trim panel.

4 Disconnect the wiring from the switch terminal, then remove the securing screw and withdraw the switch, noting its fitted position (see illustration).

13.4 Luggage compartment lamp switch location - models up to 1987
13.4 Luggage compartment lamp switch location - models up to 1987

5 Refitting is a reversal of removal, but ensure that the switch is refitted in its original position, as noted during removal, and test the operation of the switch on completion.

Models from 1987
6 Where applicable, unclip the tailgate/boot trim panel.

7 Unclip the switch from the lock assembly, disconnect the wiring plug and remove the switch.

8 Refitting is a reversal of removal.

    See also:

    Heater controls - adjustment
    1 On heaters with lever control, set both control levers approximately 2.0 mm up from their lowest setting. On heaters with rotary controls set the controls just off the COLD and CLOSED positions. ...

    Fuel filler flap
    WARNINGS: Take care when refuelling to avoid spilling any residual fuel from the fuel pipe nozzle. We recommend that you wait at least 10 seconds before removing the fuel pipe nozzle to allow an ...

    Principle of operation
    Airbags Do not modify the front of your vehicle in any way. This could adversely affect deployment of the airbags. Original text according to ECE R94.01: Extreme Hazard! Do not use a rearward f ...