Handbrake УonФ warning lamp switch - renewal

1 Disconnect the battery negative lead.

2 Working inside the vehicle, remove the handbrake lever rubber gaiter and/or the centre console, as necessary.

3 Disconnect the wiring connector from the switch, then remove the two securing screws and withdraw the switch from the handbrake lever (see illustration).

14.3 Handbrake УonФ warning lamp switch location (arrowed)
14.3 Handbrake УonФ warning lamp switch location (arrowed)

4 Refitting is a reversal of removal.

    See also:

    Fuel consumption
    The CO2 and fuel consumption figures are derived from laboratory tests according to EEC Directive 80/1268/EEC and subsequent amendments and are carried out by all vehicle manufacturers. They are ...

    Manual transmission
    All vehicles CAUTIONS: Do not engage reverse gear when the vehicle is moving. This can cause damage to the transmission. Do not apply any undue lateral force to the gear lever when changing from ...

    Sump - removal and refitting
    Note: A new gasket and new sump bolts must be used when refitting, and suitable sealant will be required (available from a Ford dealer). Note that it is preferable to keep the engine upright until ...