Lights-on warning module - renewal

1 Remove the instrument panel.

2 Unclip the direction indicator relay from the steering column support bracket (see illustration).

24.2 Lights-on warning module location
24.2 Lights-on warning module location

A Lights-on warning module B Direction indicator relay C Lights-on warning module wiring plug

3 Unclip the lights-on warning module from the steering column support bracket, disconnect the wiring plug and remove the module.

4 Refitting is a reversal of removal.

    See also:

    Electrical fault finding - general information
    Note: Refer to the precautions given in Safety first! and in Section 1 of this Chapter before starting work. The following tests relate to testing of the main electrical circuits, and should not ...

    Driving through water
    If driving through deep or standing water is unavoidable, proceed very slowly. Never drive through water that is higher than the bottom of the wheel rims (for cars) or the bottom of the hubs (for ...

    Engine/manual gearbox assembly - reconnection and refitting
    1 Reverse the procedure described in Section 11, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised. This i ...