Windscreen wiper motor and linkage - removal and refitting

Removal
1 Disconnect the battery negative lead.

2 Remove the wiper arms.

3 Remove the windscreen cowl panel.

4 Disconnect the wiring plug from the motor.

5 Remove the seven securing screws, and withdraw the mounting bracket together with the linkage and motor (see illustration).

34.5 Windscreen wiper motor bracket securing screws (arrowed)
34.5 Windscreen wiper motor bracket securing screws (arrowed)

6 Unscrew the nut securing the link arm to the motor shaft, then remove the three securing bolts, and withdraw the motor from the mounting bracket.

Refitting
7 Refitting is a reversal of removal.

    See also:

    Go-Go Gadgets
    Optional on the SE and standard on the SEL or SES, Ford's latest version of its Sync infotainment system incorporates turn-by-turn navigation via any Bluetooth-equipped mobile phone. Pair your ...

    Choke control cable - removal, refitting and adjustment
    Pre-1986 models Removal 1 Disconnect the battery earth lead. 2 For improved access, remove the air cleaner unit (Section 2). 3 At the carburettor end of the cable, loosen the cable clamp bolt, d ...

    Engine dismantling, examination, renovation and reassembly - general information
    Dismantling 1 Refer to Chapter 2, Part A, Section 18, paragraphs 1 to 8 inclusive. 2 A suitable selection of splined and Torx sockets will be required to remove many of the bolts when dismantling ...