Windscreen/headlamp washer pump - removal and refitting

Removal
1 Where headlamp washers are fitted, a separate pump is used. The pump(s) is/are a push-fit in the base of the washer fluid reservoir (see illustration).

35.1 Windscreen washer pump - models from 1987
35.1 Windscreen washer pump - models from 1987

2 Disconnect the battery negative lead.

3 To remove a pump, syphon out the contents of the reservoir, then pull the pump from its grommet.

4 Disconnect the wiring plug and the washer hose.

Refitting
5 Refitting is a reversal of removal, using a new grommet if necessary. Use a little liquid detergent as a lubricant.

6 On completion, refill the reservoir and check for correct operation.

    See also:

    Engine compartment overview - 1.4L Duratec-16V (Sigma)/1.6L Duratec-16V (Sigma)/1.6L Duratec-16V Ti-VCT (Sigma)
    A. Screen washer fluid reservoir*: See Washer fluid check. B. Engine coolant reservoir*: See Engine coolant check. C. Brake and clutch fluid reservoir (right-hand drive)*: See Brake and clutch f ...

    Heated windows and mirrors
    Heated windows Use the heated windows to defrost or demist the windscreen or rear window. Note: The heated windows operate only when the engine is running. Heated windscreen Heated rear wind ...

    Coil - testing, removal and refitting
    Testing All models except 1.6 and 1.8 litre CVH (R6A type) 1 The coil is located on the left-hand side of the engine compartment and is retained by a metal strap (see illustration). It is of high ...