Front direction indicator lamp unit - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
Low specification
2 Push the lamp unit rearwards into the bumper until the plastic retaining tang is heard to click in the locked position.

3 Withdraw the lamp unit from the front of the bumper and disconnect the wiring plug (see illustration).

44.3 Withdrawing a front direction indicator lamp unit - low specification
44.3 Withdrawing a front direction indicator lamp unit - low specification models up to 1987

4 Commence refitting by reconnecting the wiring plug.

5 Release the retaining tang, then refit the lamp unit to the bumper, ensuring that the pivot on the lamp unit engages with the slot in the bumper. Reconnect the battery.

High specification
6 Press the release lever at the top of the lamp unit upwards, and withdraw the unit from the bumper. Disconnect the wiring plug.

7 To refit, reconnect the wiring plug, then push the lamp unit into the bumper until it locates securely. Reconnect the battery.

All models from 1987
8 Working in the engine compartment, unhook the lamp unit anchor spring from its anchorage next to the headlamp, then withdraw the lamp unit sideways from its recess (see illustrations). Disconnect the bulbholder by twisting it anti-clockwise.

44.8a Unhook the front direction indicator lamp unit anchor spring . . .
44.8a Unhook the front direction indicator lamp unit anchor spring . . .

44.8b . . . and withdraw the lamp unit
44.8b . . . and withdraw the lamp unit

9 Refitting is a reversal of removal, but ensure that the locating pins on the lamp unit engage with the corresponding holes in the headlamp mounting panel.

    See also:

    Throttle body - removal and refitting
    Note: A tachometer and an exhaust gas analyser will be required to check the idle mixture on completion. A new gasket must be used when refitting the throttle body. 2.0 litre SOHC models 1 Discon ...

    Sitting in the correct position
    WARNINGS: Do not adjust the seats when the vehicle is moving. Only when you use the seat belt properly, can it hold you in a position that allows the airbag to achieve its optimum effect. W ...

    Sun blinds
    Panoramic roof The roof blind is in two sections. Pull the handle from the front or rear of the panoramic roof and fully extend the required section. To open the blind, slightly pull the handle ...