Front direction indicator side repeater lamp - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 To improve access, turn the steering onto full lock.

3 Remove the relevant wheel arch liner.

4 Working under the wheel arch, depress the retaining tabs and withdraw the lamp through the outside of the wing (see illustration).

45.4 Withdrawing a front direction indicator side repeater lamp - models up
45.4 Withdrawing a front direction indicator side repeater lamp - models up to 1987

Disconnect the bulbholder by twisting it anticlockwise.

5 Refitting is a reversal of removal.

Models from 1987
6 To improve access, turn the steering onto full lock.

7 Working in the engine compartment, disconnect the wiring plug.

8 Remove the relevant wheel arch liner.

9 Working under the wheel arch, twist the lamp clockwise and withdraw it through the outside of the wing. Feed the wiring through the holes in the wing panels.

10 Refitting is a reversal of removal.

    See also:

    Cylinder head - inspection and renovation
    Refer to Section 23, Chapter 2, Part A but pay particular attention to the note at the beginning of the Section as all CVH engines are fitted with hardened valve seats. ...

    Electronic vacuum regulator (1.8 litre (R6A type) CVH) - removal and refitting
    1 The EVR unit is located on the right-hand side of the engine compartment, near the front of the car. 2 Disconnect the battery negative lead. 3 Disconnect the EVR wiring plug, and detach the two ...

    Windscreen wipers
    Single wipe A Intermittent wipe or autowipers B Normal wipe C High speed wipe D Intermittent wipe Short wipe interval A Intermittent wipe B Long wipe interval C The rotary control can be u ...