Front foglamps - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 Remove the relevant front direction indicator lamp unit.

3 Release the retaining catch on the inside edge of the lamp, then withdraw the lamp from the bumper and disconnect the wiring plug (see illustration).

46.3 Front foglamp removal - models up to 1987
46.3 Front foglamp removal - models up to 1987

A Retaining catch

4 Refitting is a reversal of removal.

Models from 1987
5 Remove the two securing screws, then withdraw the lamp forwards and disconnect the two wiring plugs.

6 Refitting is a reversal of removal, but where necessary use a new gasket between the lamp and bumper.

7 On completion, the vertical alignment of the foglamp must be adjusted. For the foglamps, dimension “X” (see illustration, 42.4) should be taken as 220.0 mm (8.7 in). The adjuster screw is located on the inside edge of the lamp above the securing screw (see illustration).

46.7 Front foglamp adjuster screw (A) and securing screws (B) - models from
46.7 Front foglamp adjuster screw (A) and securing screws (B) - models from 1987

    See also:

    Heated windows and mirrors
    Heated windows Use the heated windows to defrost or demist the windscreen or rear window. Note: The heated windows operate only when the engine is running. Heated windscreen Heated rear wind ...

    Weber 2V carburettor automatic choke unit - removal, checking and refitting
    XR3 models Removal 1 Remove the air cleaner (Section 2). 2 Disconnect the electrical lead to the automatic choke. 3 Undo the three choke housing cover retaining screws, withdraw the cover and bi ...

    Erasing the Car2U Home Automation System buttons
    Note: The system allows for three devices to be programmed. If you need to change or replace any of the three devices after it has been initially programmed, it will be necessary to erase the curren ...