Front and rear brake pad/shoe check (Every 6000 miles (10 000 km) or 6 months)

1 Firmly apply the handbrake, then jack up the front and rear of the car and support it securely on axle stands (see “Jacking and vehicle support”).

2 For a quick check, the front brake disc pads can be inspected without removing the front wheels by inserting a mirror between each caliper and roadwheel (see illustration). If any one pad is worn down to the minimum specified thickness, all four pads (on both front wheels) must be renewed.

9.2 Using a mirror to inspect the disc pad friction material for wear
9.2 Using a mirror to inspect the disc pad friction material for wear

A Brake disc B Brake disc pads

3 It is necessary to remove the rear wheels in order to inspect the rear disc pads. The pads can be viewed through the top of the caliper after removing the blanking spring clip (see illustration). If any one pad is worn down to the minimum specified, all four pads (on both rear wheels) must be renewed.

9.3 Disc pads viewed through caliper inspection hole (roadwheel removed)
9.3 Disc pads viewed through caliper inspection hole (roadwheel removed)

4 For a comprehensive check, the brake disc pads should be removed and cleaned. The operation of the caliper can then also be checked, and the condition of the brake discs can be fully examined on both sides. Refer to Chapter 10 for further information.

5 On rear drum brake models, the brake shoe friction material can be inspected for wear without removing the roadwheels. Working beneath the vehicle, prise the plug from the brake backplate, and using an inspection lamp or torch, check that the friction material thickness is not less than the minimum given in the Specifications (see illustration). If any one of the shoes has worn below the specified limit, the shoes must be renewed as an axle set (4 shoes).

9.5 Brake shoe inspection hole plug (arrowed)
9.5 Brake shoe inspection hole plug (arrowed)

6 At the same interval, check the function of the brake fluid level warning light. Chock the wheels, release the handbrake and switch on the ignition. Unscrew and raise the brake fluid reservoir cap whilst an assistant observes the warning light: it should come on as the level sensor is withdrawn from the fluid. Refit the cap.

7 On completion, refit the wheels and lower the car to the ground.

    See also:

    4WD system (if equipped)
    Your vehicle may be equipped with a four-wheel drive (4WD) system. With the 4WD option, power will be delivered to the front wheels and distributed to the rear wheels as needed. This increases tra ...

    Windscreen cowl panel - removal and refitting
    Removal 1 Open the bonnet and disconnect the windscreen washer hose at the T-piece connector. 2 Remove both windscreen wiper arm assemblies. 3 Remove the single securing screw from each end of ...

    Oil pump - removal and refitting
    Note: A new gasket must be used on refitting. Removal 1 The oil pump is externally mounted on the rear facing side of the crankcase. 2 Using a strap wrench or similar, unscrew and remove the oil ...