Seat belt check (Every 6000 miles (10 000 km) or 6 months)

1 Periodically check the belts for fraying or other damage. If evident, renew the belt.

2 If the belts become dirty, wipe them with a damp cloth using a little detergent only.

3 Check the tightness of the anchor bolts and if they are ever disconnected, make quite sure that the original sequence of fitting of washers, bushes and anchor plates is retained.

    See also:

    Fuses, relays and circuit breakers - general information
    Pre-1986 models 1 The fuses and most of the relays are located in a plastic box attached to the bulkhead on the driver’s side of the engine compartment. 2 The fuses are numbered to identify the ...

    Checking the wiper blades
    Checking the wiper blades Run the tip of your fingers over the edge of the blade to check for roughness. Clean the wiper blade lips with water applied with a soft sponge. ...

    Rear disc splash shield - removal and refitting
    Note: A suitable puller will be required to remove the drive flange, and a new rear hub nut must be used on reassembly. Caution: Refer to the precautions in Section 1. Removal 1 Loosen the rear ...