Ignition system component check (Every 24 000 miles (40 000 km) or 2 years)

1 Before disturbing any part of the ignition system, disconnect the battery negative lead.

2 Identify and clearly mark all HT leads before disconnecting them from the spark plugs.

3 Refer to the appropriate Section in Chapter 5 and, where applicable, remove the distributor cap and rotor arm.

4 Clean the HT leads and distributor cap with a dry cloth. Scrape any corrosion or other deposits from the connectors and terminals.

Also clean the coil tower.

5 Renew the HT leads if they are cracked, burnt or otherwise damaged. If a multi-meter is available, measure the resistance of the leads. The desired value is given in the Specifications of Chapter 5.

6 Renew the distributor cap if it is cracked or badly burnt inside, or if there is evidence of “tracking” (black lines marking the path of HT leakage). If there is a carbon brush at the centre of the cap, make sure that it moves freely, and is not excessively worn (see illustration).

39.6 Bosch distributor cap showing HT segments (A) and carbon brush (B)
39.6 Bosch distributor cap showing HT segments (A) and carbon brush (B)

7 Clean the metal track of the rotor arm with fine abrasive paper. Renew the arm if it is cracked or badly burnt.

8 Refit the rotor arm and distributor cap.

9 Reconnect the HT leads to the spark plugs and coil.

10 Reconnect the battery and run the engine.

    See also:

    Idle speed compensator - removal and refitting
    Removal 1 The idle speed compensator is only fitted to K-Jetronic systems from 1986 onwards and is located in the centre of the engine compartment bulkhead (see illustration). 19.1 K-Jetronic s ...

    CD changer
    This is located under the front passenger seat. ...

    Throttle Position Sensor (TPS) - removal and refitting
    Removal 1 Disconnect the battery negative lead. 2 Unclip and disconnect the sensor wiring plug. 3 Remove the two securing screws, and withdraw the sensor from the throttle valve shaft (see illus ...