General information

The engine is of a four-cylinder, in-line, single overhead camshaft type, mounted at the front of the vehicle and available in 1.3, 1.6, 1.8 and 2.0 litre versions.

The crankshaft incorporates five main bearings. Thrustwashers are fitted to the centre main bearing in order to control crankshaft endfloat.

The camshaft is driven by a toothed belt and operates the slightly angled valves via cam followers which pivot on ball-pins.

The auxiliary shaft which is also driven by the toothed belt, drives the distributor, oil pump and fuel pump.

The cylinder head is of crossflow design with the inlet manifold mounted on the lefthand side and the exhaust manifold mounted on the right-hand side.

Lubrication is by means of a bi-rotor pump which draws oil through a strainer located inside the sump, and forces it through a fullflow filter into the engine oil galleries where it is distributed to the crankshaft, camshaft and auxiliary shaft. The big-end bearings are supplied with oil via internal drillings in the crankshaft. The undersides of the pistons are supplied with oil from drillings in the big-ends.

The distributor shaft is intermittently supplied with oil from the drilled auxiliary shaft. The camshaft followers are supplied with oil via a drilled spray tube from the centre camshaft bearing.

A semi-closed crankcase ventilation system is employed whereby piston blow-by gases are drawn into the inlet manifold via an oil separator and control valve.

    See also:

    Personalised settings
    You can change the settings of various functions through the information display. Unlocking the doors with the remote control You can set the unlocking function to unlock the driver side front do ...

    Diagram 3c. Graphic display system - bulb failure. Models from 1990 onwards
    Diagram 3c. Graphic display system - bulb failure. Models from 1990 onwards ...

    Starter motor - removal and refitting
    Removal 1 Apply the handbrake, jack up the front of the vehicle and support on axle stands (see “Jacking and Vehicle Support”). 2 Disconnect the battery negative lead. 3 Working underneath the ve ...