Engine/automatic transmission assembly - reconnection and refitting

1 Reverse the removal procedure described in Section 12, noting the following points.

2 Check that the engine adapter plate is correctly positioned on its locating dowels.

3 As the torque converter is only loosely engaged in the transmission, care must be taken to prevent the torque converter from falling out forwards. When the torque converter hub is fully engaged with the fluid pump drivegear in the transmission, distance УAФ in illustration 2.24 of Chapter 7B must be as shown. Incorrect installation of the torque converter will result in damage to the transmission.

4 As the engine and transmission are reconnected, guide the torque converter studs through the holes in the driveplate, noting that on the C3 type transmission, the torque converter fluid drain plug must line up with the opening in the driveplate (see illustration 2.25 in Chapter 7B). When the engine is positioned flush with the engine adapter plate and the transmission housing, check that the torque converter is free to move axially a small amount before refitting and tightening the engine-to-transmission bolts.

5 Do not tighten the torque converter-todriveplate nuts until the lower engine-totransmission bolts have been fitted and tightened.

6 Reconnect and adjust the selector rod.

7 Refit the propeller shaft.

8 Refit the exhaust system.

9 Fill the engine with the correct grade and quantity of oil.

10 Fill the cooling system.

11 Check and if necessary top-up the transmission fluid level.

12 Check and if necessary adjust the tension of the alternator and where applicable the power steering pump drivebelt(s).

13 Adjust the throttle cable.

14 If applicable, adjust the kickdown cable.

    See also:

    Refuelling - E85
    CAUTION: Do not attempt to start the engine if you have filled the fuel tank with the incorrect fuel. This could damage the engine. Have the system checked by a properly trained technician immedi ...

    Principle of operation
    The adaptive cruise control system is designed to help you maintain a gap from the vehicle ahead or a set road speed if there is no slower vehicle ahead. The system is intended to provide enhanced ...

    Daytime running lamps (DRL) (if equipped)
    Turns the low beam headlamps on with a reduced output. To activate: Х the ignition must be in the on position. Х the headlamp control must be in the off, parking lamps or autolamp position. Х ...