1 Make a final check to ensure that everything has been reconnected to the engine and that no rags or tools have been left in the engine bay.

2 Check that oil and coolant levels are correct.

3 Start the engine. This may take a little longer than usual as fuel is pumped up to the engine.

4 Check that the oil pressure light goes out when the engine starts.

5 Run the engine at a fast tickover and check for leaks of oil, fuel or coolant. Also check power steering and transmission fluid cooler unions, where applicable. Some smoke and odd smells may be experienced as assembly lubricant burns off the exhaust manifold and other components.

6 Bring the engine to normal operating temperature, then check the ignition timing and the idle speed (where applicable) and mixture.

7 If splined type cylinder head bolts have been used, stop the engine after it has been running for 15 minutes, then remove the crankshaft cover and tighten the cylinder head bolts to the fourth stage given in the Specifications, in the correct order.

8 When the engine has completely cooled, re-check the oil and coolant levels, and check, and if necessary adjust, the valve clearances.

9 If new bearings, pistons etc have been fitted, the engine should be run-in at reduced speeds and loads for the first 500 miles (800 km) or so. It is beneficial to change the engine oil and filter after this mileage.