Engine/manual gearbox assembly - reconnection and refitting

1 Reverse the procedure described in paragraphs 1 to 33 of Section 7, noting the following points.

2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised.

3 Check that the clutch release arm and bearing are correctly fitted, and lightly grease the input shaft splines.

4 Check that the engine adapter plate is correctly positioned on its locating dowels. If necessary, a cable-tie can be used to temporarily secure the adapter plate in position on the cylinder block, using one of the engine-to-gearbox bolt holes.

5 If shims were fitted between the sump and the gearbox, refit them in their original locations when mating the engine to the gearbox. If the engine has been overhauled, where applicable fit the relevant shims as calculated during engine reassembly.

6 Ensure that the roadwheels and the steering wheel are in the straight-ahead position before reconnecting the lower steering column to the intermediate shaft.

7 Reconnect the clutch cable to the release arm, ensuring that it is routed as noted during removal.

8 Fill the engine with the correct grade and quantity of oil.

9 Check the throttle cable adjustment.

10 Fill the cooling system.

11 Check and if necessary top-up the gearbox oil level.

12 Tighten all fixings to the specified torque, where applicable.

    See also:

    Sophisticated, Flexible Manufacturing
    As with previous models, the new S-MAX and Galaxy share the same assembly line with the Mondeo at Ford of Europe's Genk manufacturing facility in Belgium. A highly sophisticated, flexible and lean ...

    Heated seats
    CAUTION: Operating this function with the engine off will drain the battery. The heated front seats are operated by rotary controls in the instrument panel. For item location: See Quick start. T ...

    Disarming the alarm
    The system can be deactivated at any time, even when the alarm is sounding, by unlocking the vehicle from the outside. The system will be deactivated if: • A valid passive key is located within t ...