Crankshaft front oil seal - renewal

Note: A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, and a new lower timing chain cover gasket, must be used on refitting.

1 The crankshaft front oil seal is located in the lower timing chain cover.

2 If the engine is in the car, carry out the following operations:
a) Disconnect the battery negative lead.

b) To improve access, remove the radiator. It will be difficult to remove the crankshaft pulley with the radiator in place.

c) On fuel injection models, remove the air inlet hose, plenum chamber, and air cleaner lid as an assembly.

3 Proceed as described in paragraphs 3 to 8 of Section 15.

4 With the lower timing chain cover removed, prise the old oil seal from the cover using a screwdriver, and drive in the new seal using a suitable metal tube. Make sure that the seal lip faces into the engine. Take care not to damage the timing chain cover.

5 Refit the lower timing chain cover as described in paragraphs 31 to 39 of Section 15.

6 If the engine is in the vehicle, reverse the operations given in paragraph 2.

    See also:

    Hydraulic system - bleeding (anti-lock braking system)
    Note: Before starting work, refer to the warning at the beginning of Section 11 concerning the dangers of hydraulic fluid. 1 On cars equipped with the anti-lock braking system there are two bleed ...

    Auto-dimming mirror
    Auto-dimming mirror The auto-dimming mirror will adjust automatically when hit by glaring light from behind. It will not work when you have selected reverse gear. ...

    Driving on hilly or sloping terrain
    Although natural obstacles may make it necessary to travel diagonally up or down a hill or steep incline, you should always try to drive straight up or straight down. Avoid driving crosswise or turn ...