Flywheel/driveplate - removal, inspection and refitting

Note: New flywheel securing bolts must be used on refitting.

1.8 litre (R2A type)
1 Refer to Section 26, Chapter 2, Part A but also note the following points.

2 The flywheel/driveplate securing bolts must be renewed when refitting, and the new bolts are supplied ready-coated with threadlocking compound (see illustration).

24.2 Using an improvised tool to hold the flywheel stationary while
24.2 Using an improvised tool to hold the flywheel stationary while tightening the securing bolts - 1.8 litre (R2A)

3 The ring gear cannot be renewed independently of the flywheel/driveplate. If the ring gear is badly worn or has missing teeth, a new flywheel/driveplate must be fitted.

1.6 and 1.8 litre (R6A type) 4 Refer to Section 26, Chapter 2, Part A, noting the following points.

5 If the engine is in the vehicle, refer to Chapter 6 when removing the clutch.

6 The flywheel securing bolts must be renewed when refitting, and the new bolts are supplied ready-coated with thread-locking compound.

7 The ring gear cannot be renewed independently of the flywheel. If the ring gear is badly worn or has missing teeth, a new flywheel must be fitted. Similarly, the flywheel must be renewed if the crankshaft speed/position sensor toothed disc is damaged.

    See also:

    Bonnet lock - removal and refitting
    Models up to 1987 1 Working in the engine compartment, disconnect the cable from the bonnet lock by pulling the cable sheath end fitting from its bracket, then releasing the end fitting from the ...

    Brake hydraulic system seal and hose renewal (Every 36 000 miles (60 000 km) or 3 years)
    If in doubt as to the condition of any of the brake system seals and hoses, then renew defective items whilst referring to the relevant Sections of Chapter 10. ...

    Engine oil dipstick - 1.6L Duratorq-TDCi (DV) Diesel
    MIN A MAX B ...