Fuel pressure regulator (models up to 1985) - removal and refitting

Caution: Refer to the precautions in Section 1 before proceeding.

Removal
1 The fuel pressure regulator is located on the left-hand side of the engine compartment (see illustration).

5.1 Fuel pressure regulator location - models up to 1985
5.1 Fuel pressure regulator location - models up to 1985

2 Disconnect the battery negative lead.

3 Identify the fuel hose locations, as an aid to refitting. Note that there are three hose connections on models without a fuel flow sensor unit, and two hose connections on models with a fuel flow sensor unit.

4 Disconnect and plug the fuel hoses.

5 Remove the two securing screws and withdraw the regulator.

Refitting
6 Refitting is a reversal of removal, ensuring that the fuel hoses are correctly connected. If the hoses were originally secured with crimped type clips, discard them and use new worm drive clips.

    See also:

    Manual climate control
    Air distribution control Windscreen A Footwell and windscreen B Footwell C Face level and footwell D Face level E Face level and windscreen F You can set the air distribution control to any ...

    Information messages
    Press OK to acknowledge and remove some messages from the information display. Other messages will be removed automatically after a short time. With instrument cluster type 3, certain messages ...

    Fuel pressure regulator - removal and refitting
    Caution: Refer to the precautions in Section 1 before proceeding. 2.0 litre SOHC models 1 Disconnect the battery negative lead. 2 Slowly loosen the fuel feed union to relieve the pressure in the ...