Carburettor (Weber 2V type) - fast idle speed adjustment

1 This procedure does not apply to models fitted with a carburettor stepper motor, for which no adjustment is possible.

2 Check the idle speed and mixture. The idle speed must be correct before attempting to check or adjust the fast idle speed.

3 With the engine at normal operating temperature, and a tachometer connected in accordance with the manufacturer’s instructions, proceed as follows.

4 Remove the air cleaner.

5 Partially open the throttle, hold the choke plate(s) fully closed, then release the throttle so that on 1.6 litre models the fast idle adjustment screw rests on the third (middle) step of the fast idle cam (see illustration)

18.5a Fast idle speed adjustment - Weber 2V carburettor (1.6 litre models)
18.5a Fast idle speed adjustment - Weber 2V carburettor (1.6 litre models)

A Screw on third (middle) step of cam B Fast idle screw

18.5b Fast idle speed adjustment - Weber  2V
18.5b Fast idle speed adjustment - Weber 2V carburettor (2.0 litre models)

and on 2.0 litre models the fast idle adjustment screw rests on the highest step of the fast idle cam (see illustration).

6 Release the choke plate(s), checking that it/they remain(s) fully open; if not, the automatic choke mechanism is faulty, or the engine is not at normal operating temperature.

7 Without touching the throttle pedal, start the engine and check that the fast idle speed is as specified. If adjustment is necessary, turn the fast idle adjustment screw until the correct speed is obtained.

8 On completion of adjustment, stop the engine and disconnect the tachometer, then refit the air cleaner.

    See also:

    Specifications
    General Fuel tank capacity (all models) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60.0 litres (13.1 gallons) Fuel octane rating: Leaded . . . . . . . . . . . . . . . . . . . ...

    Fuel tank - removal and refitting
    The procedures are the same as described in Part A of this Chapter for carburettor engines, but in addition disconnect the fuel tank-to-fuel pump hose from the rear face of the tank. ...

    Brake pedal - removal, refitting and adjustment
    Removal 1 Working within the vehicle, remove the under-dash cover panel. 2 Extract the spring clip which connects the pushrod to the arm of the brake pedal. 3 Extract the circlip from the end of ...