Carburettor (Pierburg 2V type) - removal and refitting

1 Proceed as described for the Ford VV carburettor but note the following.

2 The Pierburg carburettor is not fitted with an anti-dieselling valve.

3 Disconnect all relevant wiring plugs and vacuum pipes, if necessary noting their locations as an aid to refitting.

4 Disconnect the throttle arm from the throttle lever by removing the retaining clip instead of disconnecting the cable (see illustration).

19.4 Throttle arm retaining clip (arrowed) -  Pierburg
19.4 Throttle arm retaining clip (arrowed) - Pierburg 2V carburettor

5 The carburettor is secured to the inlet manifold by three Torx type screws (see illustration).

19.5 Removing the carburettor securing  screws
19.5 Removing the carburettor securing screws (arrowed) - Pierburg 2V carburettor

6 On CVH models an insulator block is fitted between the carburettor and the inlet manifold in place of a gasket. There is no need to renew the insulator block on refitting.

    See also:

    Tailgate (Hatchback and Estate models) - removal and refitting
    Note: On Hatchback models made before 1990 with an integral heated rear window/radio aerial, note that the radio aerial lead is routed through different openings to that of other models in the rea ...

    Water pump - removal and refitting
    OHV engines Note: A new gasket and suitable jointing compound must be used on refitting. Removal 1 Drain the cooling system as described in Chapter 1. 2 Slacken the three water pump pulley reta ...

    Engine/manual gearbox assembly - reconnection and refitting
    1.8 litre (R2A type) 1 Reverse the procedure described in Section 10, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc ...