Fuel injector ballast resistor (1.6 litre CVH) - removal and refitting

1 The ballast resistor is located on the righthand side of the engine compartment, and is only fitted to 1.6 litre engines (see illustration).

17.1 Fuel injector ballast resistor location (arrowed)
17.1 Fuel injector ballast resistor location (arrowed)

2 Disconnect the battery negative lead.

3 Disconnect the ballast resistor wiring connector, then remove the securing screw, and withdraw the ballast resistor from the body panel.

4 Refitting is a reversal of removal.

    See also:

    Roof racks and load carriers
    Roof rack WARNINGS: If you use a roof rack, the fuel consumption of your vehicle will be higher and you may experience different driving characteristics. Read and follow the manufacturer’s inst ...

    Exceptions
    There are several exceptions to the Normal Schedule. They are listed below: Normal vehicle axle maintenance: Rear axles and power take-off (PTO) units with synthetic fluid and light-duty trucks e ...

    Automatic transmission
    WARNING: It is not possible to tow-start or push-start a vehicle fitted with an automatic transmission. See Using booster cables. Selector lever positions Park P Reverse R Neutral N Drive D ...