Exhaust gas recirculation valve (1.8 litre (R6A type) CVH) - removal and refitting

1 The EGR valve is located on the right-hand side of the engine, below the CFI unit.

2 Disconnect the battery negative lead.

3 Disconnect the vacuum hose connecting the EGR valve to the electronic vacuum regulator (see illustration).

31.3 Exhaust gas recirculation valve attachments - 1.8 litre (R6A) CVH
31.3 Exhaust gas recirculation valve attachments - 1.8 litre (R6A) CVH

A Metal tube-to-EGR valve retaining nut B Vacuum hose
C EGR valve retaining bolts D EGR valve metal tube location

4 Undo the nut securing the metal tube to the underside of the valve. Undo the two bolts, and remove the valve from the engine.

5 Refitting is a reversal of removal, but loosely fit the metal tube securing nut to the EGR valve before fitting the valve in position.

Tighten the nut securely on completion.

    See also:

    Windscreen wipers
    Windscreen wipers Single wipe A Intermittent wiping or autowipers B Normal wiping C High speed wiping D Intermittent wiping Select wipe interval with rotary switch: 1 = Short time interval. ...

    Cylinder head - dismantling and reassembly
    Note: A valve spring compressor will be required during this procedure. New valve stem oil seals should be used on reassembly. 1.8 litre (R2A type) Dismantling 1 With the cylinder head removed, ...

    Front anti-roll bar - removal and refitting
    Removal 1 To improve access, raise the front of the vehicle on ramps. Do not jack the vehicle up at this stage. Apply the handbrake. 2 Where applicable bend back the locktabs, then unscrew the tw ...