Using stability control
Using stability control
Press and hold the switch for one second.
The switch will illuminate.
Press the switch again to turn the system on. The system will be switched on automatically every time you switch the ignition on.
For item location: See Quick start.
See also:
ESC Hybrid system components - removal and refitting
Note: Procedures for removal and refitting of
the ignition system components and
electronic module are given elsewhere in the
relevant Sections of this Chapter.
1 Disconnect the battery negative l ...
Fuel filter renewal (Every 24 000 miles (40 000 km) or 2 years)
Caution: Refer to the
precautions in Chapter 4, Part
B, Section 1 before proceeding.
2.0 litre SOHC fuel injection
models
1 The fuel filter is located on the left-hand
side of the engine compart ...
Rear disc caliper - removal, overhaul and refitting
Note: Complete dismantling of the rear caliper
should not be attempted unless Ford spring
compressor (tool No 12-007) is available, or
unless the problems likely to arise in the
absence of the too ...