Load apportioning valve (P100 models) - adjustment

Models before mid-April 1989 1 The vehicle must be unladen, at normal kerb weight (a full tank of petrol, but no driver or load).

2 With the vehicle standing on its roadwheels, remove the spring clip and clevis pin, and detach the spring from the valve operating lever.

3 Loosen the locknut on the abutment block at the bottom of the spring (see illustration).

25.3 Loosen the locknut (arrowed) on the abutment block
25.3 Loosen the locknut (arrowed) on the abutment block

4 Slide the spring through the grommet in the bracket on the axle, until the correct УXФ dimension is obtained between the centre of the spring eye and the centre of the valve operating lever eye (see illustration).

25.4 Load apportioning valve adjustment
25.4 Load apportioning valve adjustment

X = 77.0 mm (3.0 in) with vehicle unladen at normal kerb weight

5 Hold the spring in position, slide the abutment block against the underside of the grommet, and tighten the locknut.

6 Attach the free end of the spring to the valve operating lever, and refit the clevis pin and spring clip.

Models from mid-April 1989 7 The procedure is as described above, but note that the dimension УXФ has been revised to 92.0 mm (3.6 in) with the vehicle unladen at normal kerb weight.

    See also:

    Engine/automatic transmission assembly - removal and separation
    Note: Refer to the warning in Section 8 before proceeding. A suitable hoist and lifting tackle will be required for this operation. Any suspected faults in the automatic transmission should be ref ...

    Engine - refitting (automatic transmission in vehicle)
    1 Reverse the procedure in paragraphs 1 to 10 of Section 6, noting the following points. 2 Check that the engine adapter plate is correctly positioned on its locating dowels. If necessary, a cable ...

    Camshafts and cam followers - removal, inspection and refitting
    Note: Once the timing chain has been removed from the camshaft sprockets, do not turn the crankshaft until the timing chain has been correctly refitted - this is to prevent contact between the val ...