Brake pedal - removal and refitting

Removal
1 Remove the clutch pedal as described in Chapter 6.

2 Extract the inboard circlip from the brake pedal end of the pivot shaft (see illustration).

30.2 Extract the inboard circlip (arrowed) to remove the pedal pivot shaft
30.2 Extract the inboard circlip (arrowed) to remove the pedal pivot shaft

3 The brake pedal can now be removed from the pedal bracket by sliding out the pivot shaft, noting the position of any washers and spacers which may be fitted.

4 If desired, the nylon bushes can be prised from each side of the pedal for renewal, and the brake lamp switch removed.

Refitting
5 Refitting is a reversal of removal, fitting any washers and spacers in their original positions. Refit the clutch pedal.

    See also:

    Child safety locks
    WARNING: You cannot open the doors from inside if you have put the child safety locks on. Left-hand side Turn anti-clockwise to lock and clockwise to unlock. Right-hand side Turn clockwise t ...

    Cylinder head - dismantling and reassembly
    Note: A valve spring compressor will be required during this procedure. New valve stem oil seals should be used on reassembly. 1 Proceed as described in Chapter 2, Part C, noting the following poi ...

    Towing a trailer
    WARNINGS: Do not exceed 100 km/h (62 mph). The rear tyre pressures must be increased by 0.2 bar (3 psi) above specification. See Technical specifications. Do not exceed the maximum vehicle and ...