Front hub carrier - removal and refitting

Note: A balljoint separator tool will be required for this operation.

Removal
1 Loosen the relevant front roadwheel nuts, apply the handbrake, jack up the front of the vehicle and support on axle stands (see “Jacking and Vehicle Support”).

2 Remove the roadwheel. On P100 models mark the position of the roadwheel in relation to one of the wheel studs before removal.

3 Remove the front brake caliper but do not disconnect the hydraulic hose. Support the caliper on an axle stand, or suspend it with wire from the coil spring to avoid straining the hose.

4 Mark the position of the brake disc in relation to the drive flange, and on Saloon, Hatchback and Estate models, remove the retaining screw or spire washer(s), as applicable, and remove the disc. On P100 models, unscrew the five retaining nuts and remove the wheel adapter plate and disc.

5 Where applicable, unbolt the ABS wheel sensor from the hub carrier and unplug the wiring connector. Place the sensor to one side.

6 Remove the split pin and unscrew the castellated nut securing the tie-rod end to the hub carrier. Using a balljoint separator tool, disconnect the tie-rod end from the hub carrier.

7 Repeat the procedure given in the previous paragraph for the lower arm-to-hub carrier balljoint.

8 Unscrew and remove the pinch-bolt which secures the hub carrier to the strut (see illustration). Using a suitable lever, such as a cold chisel, lever the hub carrier clamp legs and wedge them apart. Withdraw the hub carrier from the strut.

5.8 Unscrewing the hub carrier-to-strut pinch-bolt
5.8 Unscrewing the hub carrier-to-strut pinch-bolt

Refitting
9 Refitting is a reversal of removal, but use new split pins on the castellated nuts, and align the previously made marks on the brake disc and hub. Tighten all fixings to the specified torque.

10 On P100 models align the previously made marks on the roadwheel and wheel stud.

    See also:

    General information and precautions
    General information The fuel system on carburettor models may comprise a fuel tank, a fuel pump, a fuel pressure regulator and/or vapour separator, a downdraught carburettor and a thermostaticall ...

    Principle of operation
    Cruise control allows you to control your speed using the switches on the steering wheel. You can use cruise control when you exceed approximately 30 km/h (20 mph). ...

    Oil pump - removal and refitting
    Note: A suitable puller will be required to remove the crankshaft pulley. A new crankshaft pulley bolt, a new lower timing chain cover gasket, and a new oil pump gasket, must be used on refitting. ...