Steering column - removal and refitting

Removal
1 Set the front wheels in the straight-ahead position.

2 Disconnect the battery negative lead.

3 Remove the driver’s side lower facia trim panels.

4 Remove the screws and withdraw the steering column upper and lower shrouds (see illustrations).

24.4a Remove the steering column upper shroud . . .
24.4a Remove the steering column upper shroud . . .

24.4b . . . and lower shroud
24.4b . . . and lower shroud

5 Unscrew the two crosshead screws and withdraw the two combination switches from the column.

6 Remove the screw from the bonnet release lever and remove the lever.

7 Working in the engine compartment, unscrew the bolt securing the intermediate shaft to the inner column, swivel the clamp plate to one side, and disconnect the intermediate shaft (see illustration).

24.7 Intermediate shaft-to-inner column universal joint and clamp plate
24.7 Intermediate shaft-to-inner column universal joint and clamp plate (arrowed)

8 Unscrew the nuts securing the outer column to the facia.

9 Disconnect the multi-plugs and withdraw the column assembly upwards (see illustration).

24.9 Steering column components
24.9 Steering column components

A Direction indicator cam B Thrustwashers
C Bearings
D Outer column
E Spring
F Inner column

Refitting
10 Refit the column assembly in the car and tighten the upper mounting nuts lightly.

Loosen the mounting pinch-bolt.

11 Temporarily fit the upper column shroud and adjust the position of the steering column until there is a gap of 5.0 mm (0.2 in) between the shroud and the facia (see illustration).

24.11 Upper column shroud-to-facia gap adjustment
24.11 Upper column shroud-to-facia gap adjustment

X = 5.0 mm (0.2 in)

12 Tighten the pinch-bolt and the mounting nuts and remove the upper column shroud.

13 With the steering wheel in the straight-ahead position, reconnect the intermediate shaft and tighten the clamp plate bolt to the specified torque.

14 Refit the bonnet release lever and combination switches and reconnect the multi-plugs.

15 Refit the steering column shrouds and trim panels.

16 Reconnect the battery negative lead.

    See also:

    Engine/manual gearbox assembly - reconnection and refitting
    1 Reverse the procedure described in Section 11, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc is centralised. This i ...

    Fuel injector - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. New injector seals will be required on refitting. Removal 1 Disconnect the battery negative lead. 2 Remove the air cleane ...

    Fluid leak check (Every 6000 miles (10 000 km) or 6 months)
    1 Visually inspect the engine joint faces, gaskets and seals for any signs of water or oil leaks. Pay particular attention to the areas around the rocker cover, cylinder head, oil filter and sump ...