Manual steering gear - removal and refitting

Note: A balljoint separator tool will be required for this operation.

Removal
1 Set the front wheels in the straight-ahead position. Ensure that the steering lock is engaged and remove the ignition key.

2 Apply the handbrake. Loosen the front roadwheel nuts, jack up the front of the vehicle and support on axle stands.

3 Remove the roadwheels. On P100 models, mark the position of the roadwheels in relation to the wheel studs.

4 Unscrew and remove the clamp bolts securing the intermediate shaft flexible coupling to the steering gear.

5 If the original steering gear is to be refitted, mark the coupling in relation to the pinion. The pinion has a master spline, but making alignment marks will aid refitting.

6 Slacken the tie-rod end locknuts (see illustration).

27.6 Manual steering gear components
27.6 Manual steering gear components

A Pinion retaining nut B Pinion
C Steering gear housing
D Rack support bush
E Tie-rod
F Gaiter
G Slipper plug
H Spring
J Slipper

7 Remove the split pins and unscrew the castellated nuts from the tie-rod end-to-hub carrier balljoints.

8 Using a balljoint separator tool, disconnect the tie-rod ends from the hub carriers.

9 Unscrew the two steering gear-to-front suspension crossmember securing bolts, and withdraw the steering gear from under the vehicle.

10 If required, remove the tie-rod ends.

Refitting
11 Refitting is a reversal of removal, bearing in mind the following points.

12 If new steering gear is being fitted, the central pinion position can be ascertained by halving the number of turns required to move the rack from lock to lock.

13 Where applicable, align the marks made on the coupling and pinion.

14 When tightening the steering gear-to-front suspension crossmember bolts, the following procedure should be used. Tighten the bolts to the specified УclampingФ torque, then loosen the bolts fully. Re-tighten to the specified УsnugФ torque and then further tighten the bolts through the specified angle.

15 Tighten all fixings to the specified torque, and use new split pins on the balljoint castellated nuts.

16 On P100 models, align the previously made marks on the roadwheels and wheel studs.

17 On completion, check the front wheel alignment.

    See also:

    Diagram 5. In-car entertainment. Models from 1987 to May 1989
    Diagram 5. In-car entertainment. Models from 1987 to May 1989 ...

    Electric cooling fan - removal and refitting
    CVH models 1 Disconnect the battery negative lead. Unclip the wiring connector from the fan motor then unscrew the retaining nuts and washers. Withdraw the fan shroud and cooling fan assembly (se ...

    Changing a bulb
    WARNINGS: Switch the lights and the ignition off. Let the bulb cool down before removing it. Have Xenon bulbs changed by a trained technician. There is a risk of electric shock. CAUTIONS: Do n ...