Steering gear rubber gaiter - renewal

1 Remove the tie-rod end.

2 Unscrew and remove the tie-rod end locknut from the tie-rod.

3 Remove the clips and slide the gaiter from the tie-rod and steering gear.

4 Slide the new gaiter over the tie-rod and onto the steering gear. Where applicable, make sure that the gaiter seats in the cut-outs in the tie-rod and steering gear.

5 Secure the gaiter with new clips.

6 Refit the tie-rod end locknut to the tie-rod.

7 Refit the tie-rod end.

    See also:

    Brake pipe and hose check (Every 12 000 miles (20 000 km) or 12 months)
    Periodically inspect the rigid brake pipes for rust and other damage, and the flexible hoses for cracks, splits or “ballooning”. Have an assistant depress the brake pedal (ignition on) and inspect ...

    Engine compartment overview - 1.8L Duratorq-TDCi (Lynx) Diesel
    A. Screen washer fluid reservoir*: See Washer fluid check. B. Engine coolant reservoir*: See Engine coolant check. C. Brake and clutch fluid reservoir (right-hand drive)*: See Brake and clutch f ...

    Engine/manual gearbox assembly - reconnection and refitting
    1.8 litre (R2A type) 1 Reverse the procedure described in Section 10, noting the following points. 2 Before attempting to reconnect the engine to the gearbox, check that the clutch friction disc ...