Bonnet lock - removal and refitting

Models up to 1987
1 Working in the engine compartment, disconnect the cable from the bonnet lock by pulling the cable sheath end fitting from its bracket, then releasing the end fitting from the lock lever.

2 Remove the three securing screws and withdraw the lock from the front panel.

3 Refitting is a reversal of removal.

Models from 1987
4 Remove the radiator grille panel.

5 Disconnect the cable from the bonnet lock by pulling the cable sheath end fitting from its bracket, then releasing the end fitting from the lock lever.

6 Detach the bracing strut from the lock by removing the screw, then remove the two securing screws and withdraw the lock from the front panel.

7 Refitting is a reversal of removal.

    See also:

    Engine compartment overview - 1.4L Duratorq-TDCi (DV) Diesel
    A. Engine coolant reservoir*: See Engine coolant check. B. Brake and clutch fluid reservoir (right-hand drive)*: See Brake and clutch fluid check. C. Engine oil filler cap*: See Engine oil check ...

    Engine/automatic transmission assembly - reconnection and refitting
    1 Reverse the removal procedure described in Section 12, noting the following points. 2 Check that the engine adapter plate is correctly positioned on its locating dowels. 3 As the torque converte ...

    Air cleaner inlet air temperature control - testing
    Refer to Chapter 1, Section 36. ...