Boot lid lock (Saloon models) - removal and refitting

Removal
1 With the boot lid raised, remove the lock barrel retaining clip.

2 Where applicable, disconnect the operating lever from the central locking solenoid/motor, then withdraw the lock barrel.

3 Remove the three retaining screws from the lock assembly, if necessary loosening the reinforcing plate (see illustration).

10.3 Boot lid lock - Saloon models
10.3 Boot lid lock - Saloon models

A Lock retaining screws B Earth lead
C Reinforcing plate screws

4 Where applicable, disconnect the battery negative lead, the earth lead from the bootlid and the Уboot lid ajarФ sensor wiring plug.

Unclip the luggage compartment light switch from the lock assembly, where applicable.

5 Withdraw the lock assembly from the boot lid.

Refitting
6 Commence refitting by inserting the lock assembly and loosely refitting the retaining screws.

7 Insert the lock barrel, where applicable reconnecting the operating lever to the solenoid, and refit the retaining clip.

8 Tighten the lock assembly retaining screws, and where applicable reconnect the earth lead and Уboot lid ajarФ sensor wiring plug, and the battery negative lead.

9 If the reinforcing plate was loosened during removal, tighten the retaining screws.

    See also:

    Seat belt height adjustment
    Seat belt height adjustment Note: Lifting the slider slightly while pressing the locking button makes it easier to release the locking mechanism. To raise or lower, press the locking button on ...

    Manual seats
    WARNINGS: Do not use any accessory seat covers that are not specifically designed for seats with side airbags. These seat covers must be fitted by properly trained technicians. Do not adjust the ...

    Fuel quality - Petrol
    Note: We recommend that you use only high quality fuel without additives or other engine treatments. CAUTION: Do not use leaded petrol or petrol with additives containing other metallic compound ...