Door interior handle - removal and refitting

Removal
1 Remove the door inner trim panel.

2 Where necessary for improved access, peel back the waterproof plastic sheet from the door.

3 Remove the two securing screws in the case of models up to 1987, or the single securing screw on models from 1987, and slide the handle assembly from the door aperture, if necessary unclipping the remote control rods from their guides (see illustrations).

18.3a Remove the securing screws . . .
18.3a Remove the securing screws . . .

18.3b . . . and slide the handle assembly from the door aperture
18.3b . . . and slide the handle assembly from the door aperture

4 Disconnect the remote control rods from the handle assembly, and withdraw the handle assembly.

Refitting
5 Refitting is a reversal of removal, but check that the remote control rods are correctly located in their guides (see illustration).

18.5 Remote control rods correctly located in their guides
18.5 Remote control rods correctly located in their guides

    See also:

    Handbrake cables - renewal
    1 Chock the front wheels, then fully release the handbrake. 2 Raise and support the vehicle at the rear with axle stands (see “Jacking and Vehicle Support”). Primary cable 3 Extract the spring c ...

    Carburettor (Weber 2V type) - removal and refitting
    1 Proceed as described for the Ford VV carburettor but note the following. 2 On models with an electrically-heated automatic choke, ignore all references to the cooling system and coolant hoses. ...

    Create a MyKey
    To program MyKey on one of the keys programmed to the vehicle, insert the key that you want to make a MyKey into the ignition. Turn the ignition on. Use the message center buttons to do the followin ...