Door window regulator - removal and refitting

Removal
1 Remove the door inner trim panel.

2 Where necessary for improved access, peel back the waterproof plastic sheet from the door.

3 Lower the window until the lower support channel is visible through the lower door aperture. Prise the regulator arms from the sockets in the support channel, then lower the window to the bottom of the door (see illustration).

28.3 Front door window lower support channel and regulator arms
28.3 Front door window lower support channel and regulator arms

4 Drill out the four rivets securing the regulator assembly to the inner door skin, and if working on a front door, drill out the two rivets securing the regulator guide (see illustration).

28.4 Door window regulator fixings
28.4 Door window regulator fixings

A Front door
B Rear door
C Regulator assembly securing rivets D Regulator guide rivets

5 On models with electric windows, disconnect the motor wiring plug after disconnecting the battery negative lead.

Removal and refitting of the motor is described in Chapter 13.

6 Withdraw the regulator assembly through the lower door aperture.

Refitting
7 Refitting is a reversal of removal, but fit new rivets, using a hand riveter.

    See also:

    Child seats
    WARNINGS: Secure children that are less than 150 centimetres tall or less than 12 years of age in a suitable, approved child restraint, in the rear seat. Original text according to ECE R94.01: ...

    Detachable tow ball
    WARNINGS: Never leave the detached tow ball arm unsecured inside the vehicle. This would increase the risk of injury in an accident. Take special care when fitting the tow ball arm as the safety ...

    Brake lamp switch - renewal
    1 Disconnect the battery negative lead. 2 Unclip the trim panel from the lower edge of the driver’s side lower facia trim panel. If required for improved access, remove the lower facia trim panel. ...