Fuel filler flap - removal and refitting

Removal
1 Open the filler flap and the tailgate or boot lid, as applicable.

2 Remove the fuel filler cap and then remove the screw securing the filler housing to the fuel tank neck (see illustration).

37.2 Fuel filler housing securing screw (arrowed)
37.2 Fuel filler housing securing screw (arrowed)

3 Working inside the luggage compartment, depress the filler housing retaining tangs, and push the assembly out through the body panel. Recover the gasket.

4 Immerse the housing assembly in a container of hot water for approximately ten minutes, then prise the hinge cover from the housing, and using a screwdriver, prise the filler flap hinge legs out of the sockets in the housing.

Refitting
5 Commence refitting by warming the filler flap and housing, as during removal, then push the flap hinge legs into the housing.

6 Further refitting is a reversal of removal, ensuring that the housing gasket and retaining tangs are correctly located.

    See also:

    Vacuum servo unit and linkage - removal and refitting
    Removal 1 Refer to Section 12 and remove the master cylinder. 2 On fuel-injection models unclip and lift out the front section of the heater plenum chamber to provide access to the connecting li ...

    General information
    WARNINGS: Use load securing straps to an approved standard, e.g. DIN. Make sure that you secure all loose items properly. Place luggage and other loads as low and as far forward as possible wit ...

    Crankshaft rear oil seal - renewal
    1 Remove the flywheel/driveplate. 2 Prise out the oil seal. If necessary, drill the outer face of the oil seal and use self-tapping screws and a pair of grips to withdraw the seal (see illustratio ...