Electric door mirror switch - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 Using a thin-bladed screwdriver, carefully prise the switch from the door trim panel.

3 Disconnect the wiring plug and withdraw the switch (see illustration).

10.3 Disconnect the wiring plug from the door mirror switch - models up to
10.3 Disconnect the wiring plug from the door mirror switch - models up to 1987

4 Refitting is a reversal of removal.

Models from 1987
5 Prise the securing screw cover from the mirror control panel, then remove the screw and withdraw the control panel.

6 Depress the switch retaining tang, then withdraw the switch from the control panel and disconnect the wiring plug.

7 Refitting is a reversal of removal.

    See also:

    Safety restraints for children
    See the following sections for directions on how to properly use safety restraints for children. Also see Airbag supplemental restraint system (SRS) in this chapter for special instructions about us ...

    Reversing lamp switch - renewal
    1 For automatic transmission models, refer to Chapter 7, Part B. For manual gearbox models, proceed as follows: 2 Disconnect the battery negative lead. 3 Apply the handbrake, jack up the front of ...

    Accelerator pedal - removal and refitting
    The procedure is the same as described in Part A of this Chapter for carburettor models. ...