Luggage compartment lamp switch - removal and refitting

1 Disconnect the battery negative lead.

Models up to 1987
2 A level-sensitive switch is fitted to the tailgate.

3 Unclip the tailgate trim panel.

4 Disconnect the wiring from the switch terminal, then remove the securing screw and withdraw the switch, noting its fitted position (see illustration).

13.4 Luggage compartment lamp switch location - models up to 1987
13.4 Luggage compartment lamp switch location - models up to 1987

5 Refitting is a reversal of removal, but ensure that the switch is refitted in its original position, as noted during removal, and test the operation of the switch on completion.

Models from 1987
6 Where applicable, unclip the tailgate/boot trim panel.

7 Unclip the switch from the lock assembly, disconnect the wiring plug and remove the switch.

8 Refitting is a reversal of removal.

    See also:

    Compression test
    Refer to Section 5, Chapter 2, Part A. ...

    Sump - removal and refitting
    Note: A new gasket and new sump bolts must be used when refitting, and suitable sealant will be required (available from a Ford dealer). Note that it is preferable to keep the engine upright until ...

    Calculating fuel economy
    1. Fill the fuel tank completely and record the initial odometer reading (in miles or kilometers). 2. Each time you fill the tank, record the amount of fuel added (in gallons or liters). 3. After ...