Wiper arms - removal and refitting

Windscreen and rear wipers 1 Lift the hinged covers and remove the nuts and washers securing the arms to the spindles.

2 Mark the arms and spindles in relation to each other then prise off the arms using a screwdriver.

Take care not to damage the paintwork.

3 Refitting is a reversal of removal.

Headlamp wipers
4 The procedure is as described in paragraphs 1 to 3, but the washer hose must be disconnected from the nozzle on the wiper arm (see illustration).

32.4 Removing a headlamp wiper arm
32.4 Removing a headlamp wiper arm

    See also:

    Idle speed linkage clean (Every 12 000 miles (20 000 km) or 12 months)
    On carburettor models which incorporate a stepper motor (ie. Weber 2V from 1985), good electrical contact between the motor plunger and the adjusting screw is essential to maintain a regular idle ...

    Manual steering gear - removal and refitting
    Note: A balljoint separator tool will be required for this operation. Removal 1 Set the front wheels in the straight-ahead position. Ensure that the steering lock is engaged and remove the igniti ...

    Alternator - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. Removal 1 The operations are similar for all makes of alternator. 2 Disconnect the battery negative terminal, then disco ...