Washer nozzles - removal and refitting

Windscreen and rear window washers
1 To remove a nozzle, carefully prise it from its location using a thin-bladed screwdriver.

Disconnect the washer hose and withdraw the nozzle.

2 To refit, reconnect the washer hose to the nozzle, and push the nozzle into its locating hole.

3 The nozzles can be adjusted by inserting a pin into the jet and swivelling to the required position.

Headlamp washers
Models up to 1987
4 Remove the radiator grille panel.

5 Disconnect the washer hose from the nozzle.

6 Separate the upper and lower halves of the nozzle by prising apart with a thin-bladed screwdriver, then withdraw the nozzle halves.

7 Refitting is a reversal of removal.

8 The nozzles can be adjusted as described in paragraph 3.

Models from 1987
9 Disconnect the washer hose from the nozzle on the end of the wiper arm.

10 Prise the combined wiper blade mounting and nozzle from the wiper arm using a thinbladed screwdriver or a pair of pliers.

11 Refitting is a reversal of removal.

12 Note that the nozzles are not adjustable.

    See also:

    Headlining - removal and refitting
    Saloon, Hatchback and Estate models 1 On Saloons, remove the rear seat back. 2 Loosen the upper screws of all the pillar trim panels touching the headlining. 3 Prise off the covers and remove the ...

    Windows and wiper blades
    The windshield, rear and side windows and the wiper blades should be cleaned regularly. If the wipers do not wipe properly, substances on the vehicle’s glass or the wiper blades may be the cause. Th ...

    Engine - removal leaving manual gearbox in vehicle
    Warning: Vehicles equipped with air conditioning: Components of the air conditioning system may obstruct work being undertaken on the engine and it is not always possible to unbolt and move them ...