Headlamps - alignment

1 It is recommended that the headlamp alignment is carried out by a Ford dealer using specialist beam setting equipment. However, in an emergency the following procedure will provide an acceptable light pattern.

2 With the vehicle unladen, with a full tank of fuel, and with the tyres correctly inflated, position the vehicle approximately 10 metres (33 feet) in front of, and at right-angles to, a wall or garage door.

3 Draw a vertical line on the wall corresponding to the centre line of the car.

The position of the line can be ascertained by marking the centre of the front and rear screens with crayon then viewing the wall from the rear of the car.

4 Complete the lines shown (see illustration).

42.4 Headlamp alignment chart
42.4 Headlamp alignment chart

A Distance between headlamp centres B Light/dark boundary
C Centre of dipped beam
D Dipped beam pattern
H Height of headlamp centre from ground X = 160.0 mm (6.3 in) for all models up to 1987 120.0 mm (4.7 in) for all models from 1987

5 Switch the headlamps on dipped beam and adjust them as necessary using the knobs located behind the headlamps (see illustration). Cover the headlamp not being checked with cloth.

42.5 Adjusting the headlamp alignment
42.5 Adjusting the headlamp alignment

    See also:

    Brake pedal - removal and refitting
    Removal 1 Remove the clutch pedal as described in Chapter 6. 2 Extract the inboard circlip from the brake pedal end of the pivot shaft (see illustration). 30.2 Extract the inboard circlip (arro ...

    Child seats
    WARNINGS: Secure children that are less than 150 centimetres tall or less than 12 years of age in a suitable, approved child restraint, in the rear seat. Original text according to ECE R94.01: ...

    Internal connection details, all models
    Internal connection details, all models ...