Changing the remote control battery

Make sure that you dispose of


Make sure that you dispose of old batteries in an
environmentally friendly way.

Seek advice from your local authority regarding recycling.

Remote control with a folding key blade
Remote control with a folding key blade

1. Insert a screwdriver as far as possible into the slot on the side of the remote control, push it towards the key blade and remove the key blade.

2. Twist the screwdriver in the position


2. Twist the screwdriver in the position shown to start separating the two halves of the remote control.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

Remote control without a folding key blade

Type 1
Type 1

1. Insert a screwdriver into the recess on the back of the key and remove the key blade.

2. Release the retaining clips with the screwdriver and separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

3. Carefully prise out the battery with the screwdriver.

4. Install a new battery (3V CR 2032) with the + facing upwards.

5. Assemble the two halves of the remote control.

6. Install the key blade.

Type 2
Type 2

1. Slide the release slider in the direction of the arrow.

2. Remove the key blade.

3. Twist the screwdriver in the position


3. Twist the screwdriver in the position shown to separate the two halves of the remote control.

CAUTION:
Do not touch the battery contacts or the printed circuit board with the screwdriver.

4. Carefully prise out the battery with the screwdriver.

5. Install a new battery (3V CR 2032) with the + facing downwards.

6. Assemble the two halves of the remote control.

7. Install the key blade.

    See also:

    Front anti-roll bar-to-lower arm compliance bushes - renewal
    Note: The compliance bushes must be renewed in vehicle sets, therefore the bushes on both sides of the vehicle must be renewed at the same time. If plastic covers were not originally fitted betwee ...

    Hyundai tooday
    Автомобильный производитель Hyundai по статистическим показателям занимает высокую строчку в рейтинге, который рассказывает о количестве проданных за год машин. Этим можно объяснить, почему же на улиц ...

    Direction indicator and hazard warning flasher switch assembly - renewal
    1 Disconnect the battery negative lead. 2 Remove the securing screws and unclip the lower and upper steering column shrouds. 3 Remove the two securing screws and disconnect the two wiring plugs, t ...